1. Pretreatment of the restoration surface
1-1. Extraoral use Sandblast the adhesive metal surface with 50-100 μm aluminum oxide at approx. 0.3-0.5 MPa / 3-5 bar. Then, perform ultrasonic cleaning and dry with clean air. Sandblast can be replaced by roughing the surface with a suitable abrasive (eg. diamond bur etc)
1-2. Intraoral use Place rubber dam and avoid direct contact with oral tissue. Roughen the adhesive metal surface using a dental abrasive (eg. diamond bur etc), rinse with water and dry with clean air
2. Application Dispense adequate amount of M.L. Primer on a dish. Apply to the entire adhesive surface in one layer with a disposable brush. Leave it undisturbed for 10 sec. and dry naturally
3. Bonding to resin material Bond resin material according to the instructions for use of each product.