TempoCem NE zinc oxide non-eugenol cement is ideal for use in cases where a eugenol temporary cement is not recommended. Because any residue of eugenol may inhibit the polymerization of resin materials, TempoCem NE's non-eugenol formula is perfect for cases in which a resin material or a resin reinforced glass ionomer will be used for the final restoration.
COMPOSITION:
Catalyst paste: Natural resins, fatty acids, additives
Base paste: Zinc oxide, paraffin, additives
INDICATIONS:
Temporary cementation of provisional and permanent crowns and bridges, inlays and onlays.
CONTRAINDICATIONS:
Do not use the material in cases of allergies to any of the substances contained or, as can occur in rare cases, in the event of contact allergy.
Non-eugenol formulation
• Ideal for use in cases where a eugenol temporary cement is not recommended.
• Won't inhibit the polymerization of resin materials.
• Perfect for cases in which a resin material or a resin reinforced glass ionomer will be used for the final restoration.
Offers optimally adjusted adhesion
• Resists forces of mastication.
• Securely retains the restoration and maintains patient comfort.
• Is flexible under the crown for easy removal of the temporary.
Resistant to saliva
• Increases stability of cement in the mouth.
Biocompatible
• Protects the gingival tissue.
300+% radiopacity
• Visible on x-ray.
Easy flow
• Permits precise placement of cement and easy placement of the temporary.
No heat generated during setting
• Protects pulp.
Insulates prep against thermal sensitivity
• For greater patient comfort.
Less waste in cement tip than created by hand mixing
• More economical.
TECHNICAL DATA:
Composition : Zinc oxide-non-eugenol
Working Time : 1 minute
Complete Setting Time : 4-5 minutes intra-orally
Film Thickness : ≤ 20μm
Compression Strength : <=35MPa
Radiopacity : ≥ 200%
Diametrical Tensile Strength :36 MPa
Mixing Ratio (Base/Catalyst) 10:1 (Volume)
BASIC SAFETY OINSTRUCTIONS:
STORAGE & SHELF LIFE:
Temporary cementation
1. Apply TempoCemNE to the dry temporary restoration
2. Insert the temporary restoration within 1:00 min of start of mixing and attach to the dry, prepared tooth using slight pressure
3. After curing, remove excess cement with a probe
4. It is easy to remove excess cement in large chunks
5. Remove interdental excess by flossing carefully
6. The light color of the material makes it easy to distinguish from teeth.
Using the Automix cartridge
Insert cartridge
1. Push up the lever at the back of the Automix dispenser and pull back the slide completely.
2. Lift up the plastic lever, insert the cartridge and lock it using the plastic lever
Please note: Make sure that the notches on the cartridge line up with those on the Automix dispenser.
