Honigum-Putty offers extraordinary recovery after deformation thus facilitating a precise reproduction of the oral situation. A precise detail reproduction is guaranteed.
Thanks to the DMG-developed Snap-Set technology the new Honigum-Putty offers a so far unrivaled combination of comfortable working time and short time in mouth. Its generous working time reduces the »mix stress« to a minimum. Deformations due to already set material are prevented, and micro movements are reduced by the quicker cross linking. For the patient the shorter time in mouth translates into significantly more comfort during the treatment.
Honigum-Putty is an impression material based on addition curing silicones. The material is available as a hand-mix version and in the ready-to-use pre-filled MixStar cartridge, which is suitable for use in the DMG MixStar-eMotion and other commercially available mixing machines.
- Vinyl polysiloxanes
- Hydrogen polysiloxanes
- Silicium dioxide
- Platinum catalyst
1. Fill the tray with Honigum-Putty.
2. Syringe the preparation with Honigum-Light. Observe the associated instructions for use! Note: The filling of the tray and syringing should be completed at the same time as the higher temperature in the mouth leads to a quicker setting of the syringed material compared to the tray material. 3. Position the filled tray in the mouth within the working time, slowly and using very little force, and allow the impression to form. 4. Remove the impression from the mouth once the setting time has elapsed,
- Crown and bridge impressions
- Inlay and onlay impressions